Paint Booth Relocation in Memphis / North Mississippi
Double D Mechanical relocates paint booths for Memphis and North Mississippi facilities that need to shift finishing operations with changing production needs. The move should be planned around equipment handling, airflow, utilities, building clearances and the way parts travel through prep, coating and exit areas.
Discuss your installationEquipment Handling From Old Location to New
Booth panels, doors, plenums, lights, filters, fans and duct sections need a teardown and staging sequence. Labeling components and documenting connections helps reassembly stay organized, especially when work must happen around active production.
Part Path Through the Finishing Area
A relocated booth should support the full route from incoming work to coated part exit. Review the new position for racks, carts, lift trucks, long components, masking space and finished work staging so the booth does not become a bottleneck.
- Measure part length, width and height with handling equipment included.
- Confirm approach lanes before anchoring equipment.
- Leave room for filter service and door maintenance.
Airflow Changes After Relocation
The new location may require revised exhaust duct, fan supports, discharge location and make-up air delivery. Building pressure, nearby intakes and overhead conflicts should be reviewed before the booth is set and utilities are routed.
Utility and Controls Planning
Electrical feeds, controls, lighting, gas and compressed air need defined routes in the new location. Coordinating these connections with mechanical installation helps keep service access open and avoids rework above or behind the booth.
What to Prepare for the Site Visit
Have the current booth location, proposed layout, photos, utility information, roof notes, part dimensions and production constraints ready. If equipment drawings are not available, photos of nameplates, fan assemblies and control panels can help.
Planning a booth or oven project in Tennessee
Crews mobilize from Houston; Tennessee is roughly 650 miles away, so equipment, panels and tooling are staged and shipped ahead of the install crew.
Manufacturing in Tennessee is concentrated around Nashville, Memphis, Knoxville, and Chattanooga. The sectors most likely to be specifying spray booths, blast rooms, powder systems and cure ovens there include automotive assembly and EV, appliances, chemicals, and aerospace.
Hot, humid summers and mild winters put the emphasis on make-up air cooling or tempering, filter change schedules and keeping intake away from loading doors.
Frequently asked questions
What should be measured before moving a paint booth?
Measure the booth, duct runs, doors, aisles, overhead clearances, part sizes, handling equipment and the proposed footprint.
Can the booth move while nearby production continues?
Sometimes nearby work can continue, but the plan must protect access paths, staging zones, utility work areas and safety around lifts or overhead work.
Does relocation affect make-up air?
Yes. The make-up air route, discharge point, duct supports and relationship to booth exhaust may all change with the new location.
What is useful if there are no original drawings?
Clear photos, measurements, model information, utility notes and a marked floor plan can support planning when original drawings are missing.