Relocating a Used or Acquired Paint Booth in Georgia
Buying a used booth, inheriting one with a building purchase or taking over equipment from a closed plant can save time, but only if the booth is worth moving and fits where it is going. Double D Mechanical relocates used and acquired paint booths for Georgia facilities, from condition review at the old site through reinstallation and startup at the new one.
Discuss your installationIs the Used Booth Worth Moving?
A booth that looks fine from the floor can hide problems. Walking it before purchase or teardown shows what can be reused and what will need replacing.
- Panels bent, rusted or holed by forklifts
- Door seals, hinges and latches worn out
- Exhaust fan wheel, bearings and motor condition
- Light fixtures, lenses and wiring
- Control panel age and parts availability
Missing Drawings and Unknown History
Used booths often arrive with no manual, no layout drawings and no record of past changes. Measuring and photographing the booth in place, reading every nameplate and sketching the plenum and duct arrangement before disassembly rebuilds the information needed to put it back together correctly.
Fitting the Booth to Your Building and Utilities
The booth's original exhaust, make-up air and electrical arrangement was designed for someone else's building. At the new site the duct route, heater location, gas service, electrical supply and controls are laid out again for the new space, and the booth's air volume is confirmed against what the new fans and heater will deliver.
Transformer Work Near Savannah and Growth Around Atlanta
The Virginia Transformer plant in Rincon is one example of new power equipment manufacturing in coastal Georgia, while the Atlanta area keeps adding industrial and fleet operations. Growing operations in both regions sometimes turn to used finishing equipment to get a booth running sooner.
Planning a booth or oven project in Georgia
Crews mobilize from Houston; Georgia is roughly 700 miles away, so equipment, panels and tooling are staged and shipped ahead of the install crew.
Manufacturing in Georgia is concentrated around Atlanta, Savannah, Augusta, and Columbus. The sectors most likely to be specifying spray booths, blast rooms, powder systems and cure ovens there include automotive assembly and EV, aerospace, transportation equipment, and heavy machinery.
Hot, humid summers and mild winters put the emphasis on make-up air cooling or tempering, filter change schedules and keeping intake away from loading doors.
Frequently asked questions
Can a booth bought at auction be reinstalled?
Often yes, if the panels, fans and controls are in usable condition and the booth fits the new building. A condition review before purchase is the best protection.
Which parts of a used booth commonly need replacement?
Filters and door seals almost always. Lights, fan parts and controls depend on age and condition.
Does an older booth need new controls?
Not always, but older panels may lack current interlocks or have parts that are hard to find. The panel is reviewed during the condition walk.
Who takes the booth out of the seller's building?
Double D can disassemble and remove the booth from the old site, subject to access arrangements with the seller.
What should be sent before reviewing a used booth?
Photos of every side, the plenum, fans, heater and control panel, any paperwork that came with it, nameplate photos and the layout of the building where it will go.