Open Face Paint Booths for North Carolina Furniture and Fabrication
Open face booths do a lot of quiet work in North Carolina plants. Furniture and fixture shops use them for finishing parts and assemblies; fabricators use them for touch-up and components; equipment suppliers use them for smaller parts that do not justify an enclosed booth. Double D Mechanical installs, moves and services open face booths and the exhaust and air systems around them.
Discuss your installationSmaller Parts Around Big Plants
Large equipment plants like Deere's excavator plant in Kernersville anchor networks of suppliers producing hoses, brackets, guards and small fabrications. Many of those parts are painted or touched up in open face booths beside the work cell, because there is no door to slow production and the booth can be placed right where the parts are made.
Furniture and Fixture Finishing
Wood and mixed-material finishing brings its own priorities. Overspray from lacquers and stains needs reliable exhaust, and dust from sanding is the enemy of a good finish.
- Separate sanding and dust collection from the finishing area
- Use filters suited to the coatings being sprayed
- Keep make-up air clean and away from the booth face
- Plan drying space so finished parts are not carried through dusty areas
Installation Basics
We set the booth, install the exhaust chamber, fan and stack, and coordinate electrical for fans and lights. Where the building needs replacement air, we install a make-up air unit and interlock it with the booth. Fire protection interlocks and sprinklers are coordinated with your fire protection contractor.
Relocating With the Line
When production lines get rearranged, open face booths often move with them. We take the booth down, move the stack and ductwork, and reconnect at the new location, checking airflow before production resumes.
Planning a booth or oven project in North Carolina
Crews mobilize from Houston; North Carolina is roughly 950 miles away, so equipment, panels and tooling are staged and shipped ahead of the install crew.
Manufacturing in North Carolina is concentrated around Charlotte, Raleigh and Durham, Greensboro, and Winston-Salem. The sectors most likely to be specifying spray booths, blast rooms, powder systems and cure ovens there include aerospace, automotive and EV, furniture, and heavy trucks.
Hot, humid summers and mild winters put the emphasis on make-up air cooling or tempering, filter change schedules and keeping intake away from loading doors.
Frequently asked questions
Are open face booths suitable for wood finishing?
Yes, they are widely used for furniture and fixture parts. Filter selection and dust control around the booth matter for finish quality.
How big can an open face booth be?
They come in many widths and heights. The booth should fit the largest part with room for the operator to move around it.
Does the booth need to be near an exterior wall?
Not necessarily, but shorter exhaust runs to the roof or wall are simpler and cheaper.
What causes overspray to escape the booth face?
Loaded filters, a weak fan, cross drafts in the shop, or a building that is too negative. We check each during service.