Sandblast booth installation for oil and gas fabrication
Oil and gas fabrication shops use abrasive blasting to prepare skids, pipe spools, supports, frames and equipment components before coating. Double D Mechanical installs sandblast booths, blast rooms and media reclaim systems with attention to large workpieces, airflow, dust collection, compressed air, exhaust routing and maintenance clearance.
Discuss your installationFit for Skids and Pipe Assemblies
Oil and gas workpieces can include long pipe sections, welded frames and bulky assemblies with lifting points. Booth layout should account for forklift access, cranes, carts, part rotation and technician reach around welds, flanges and corners.
Airflow for High-Dust Prep Work
Abrasive blasting creates heavy dust loads that need controlled capture. Fan selection, collector placement, duct paths, inlet air and make-up air all influence visibility, containment and comfort around the booth.
Reclaim Planning for Abrasive Media
Media recovery can involve sweep-in floors, screw conveyors, pneumatic reclaim or other equipment arrangements. Each option affects slab work, equipment location, cleanout access and the path for loading and removing parts.
Tie-Ins Near Fabrication Lines
Compressed air, electrical service, lighting, controls and exhaust penetrations must be coordinated with welding stations, coating areas, material racks and overhead handling equipment. Good sequencing keeps installation work from fighting the production layout.
What to Bring to Layout Review
The most useful planning information comes from the real parts and the way they move through the shop.
- Longest pipe or skid dimensions
- Forklift, crane and cart access requirements
- Preferred blast media and recovery approach
- Existing compressor, electrical and roof information
Frequently asked questions
Why do oil and gas fabrication shops need careful booth sizing?
Long parts and welded assemblies need room for loading, turning and operator access. The booth has to fit the workflow, not only the part envelope.
What does the dust collector need around it?
Collectors need space for filter changes, hopper access, discharge handling, controls and duct connections. Crowding that equipment can make service difficult.
Can a blast booth be placed near coating equipment?
It can be planned as part of a prep and coating flow, but dust containment, exhaust direction, staging space and material handling paths need close review.
What compressed air details matter?
Available pressure, volume, piping route, dryer location and connection points should be checked against the blast equipment requirements.
When should floor recovery be discussed?
Early in planning. Recovery equipment can affect concrete work, booth elevation, drainage concerns, housekeeping and the installation sequence.