Paint booth removal for oil and gas fabrication
Oil and gas fabrication shops often finish skids, pipe supports, frames, vessels and welded assemblies that demand wide aisles and clear crane or forklift movement. Double D Mechanical removes paint booths with attention to booth panels, exhaust duct, make-up air, utility disconnects, roof or wall openings, staging space and the production areas that must keep moving around the work.
Discuss your installationClearing space around heavy fabrication
Removal planning starts with the booth footprint, the size of nearby workpieces and the route for taking panels, fans and duct sections out of the building. Large fabricated assemblies may limit where lifts, carts and temporary staging can sit, so the sequence should protect active welding, fit-up and coating lanes.
Exhaust and air connections to isolate
Paint booth removal usually involves exhaust fans, ductwork, dampers, intake plenums and make-up air connections. Each connection should be identified before teardown so the facility knows what will be disconnected, capped, left for another system or opened for later work.
Utility routes before teardown
Gas, power, compressed air, controls and lighting circuits can run through or near booth assemblies. Double D Mechanical plans removal around clear isolation points and coordinates with plant trades so utility work does not block cranes, welding leads, hose reels or material routes.
Site details to prepare
Useful information includes booth drawings, fan and heater data, roof curb locations, utility panels, recent photos, floor traffic routes and the desired final condition of openings, pads and remaining duct. Marking nearby equipment that must stay in service helps the removal plan fit the shop.
Frequently asked questions
What should be reviewed before removing a booth in an oil and gas fabrication shop?
Review the booth layout, exhaust route, make-up air connections, utility feeds, roof or wall penetrations, nearby cranes and the route for removing large components.
Can removal be planned around ongoing fabrication work?
Yes. The plan should define staging zones, traffic aisles, lift access and utility isolation so the removal work does not conflict with active production areas.
What happens to old exhaust ductwork?
Ductwork can be removed, shortened, capped or left for another planned use depending on the facility goal and the condition of the connected systems.
Who should attend the site walk?
Plant management, maintenance, safety, production supervision and the electrical or mechanical trades involved in disconnects should be part of the review.