Paint Booth Removal in Idaho
Double D Mechanical removes paint booths from Idaho shops and industrial facilities that are replacing a finish line, changing part handling, or opening space for a new process. A good removal plan ties together booth structure, workpiece access, ductwork, make-up air, utilities, clearances, and the sequence for other trades.
Discuss your installationWorkpiece Flow After the Booth Leaves
Removing a booth often changes how parts, racks, carts, or vehicles move through the department. Facility teams should decide whether the area will become open floor space, a new finishing cell, a staging zone, or an access path before disassembly begins.
Utilities and Control Points
Power, lighting, gas, compressed air, control wiring, and interlocks may be routed through the booth or above it. Tracing those connections helps define what is disconnected, what is labeled for later use, and what must remain available for nearby equipment.
Duct Support and Fan Removal
Exhaust duct and fan assemblies can require separate planning from the booth enclosure. Supports, roof curbs, stacks, vibration isolators, weather caps, and access to overhead work all affect how the system is removed and how the opening is handled afterward.
Idaho Site Review Checklist
The site review should capture both the mechanical scope and the practical handling details.
- Booth dimensions, door swing, pit or floor condition, and panel layout
- Fan, duct, stack, and make-up air unit locations
- Electrical, gas, compressed air, and controls isolation points
- Available lifts, aisle routes, overhead clearance, and exterior access
- Desired condition of walls, floor, roof openings, and remaining utilities
Planning a booth or oven project in Idaho
Crews mobilize from Houston; Idaho is roughly 1,500 miles away, so equipment, panels and tooling are staged and shipped ahead of the install crew.
Manufacturing in Idaho is concentrated around Boise, Idaho Falls, and Coeur d'Alene. The sectors most likely to be specifying spray booths, blast rooms, powder systems and cure ovens there include semiconductors, food processing equipment, wood products, and trailer and recreational manufacturing.
Cold winters mean make-up air heaters are sized for sub-freezing intake, and booth or oven placement has to account for frost lines, snow loads on roof penetrations and winter slab work.
Frequently asked questions
Does the booth need to be cleaned out before removal?
The facility should remove loose materials, parts, tools, filters as directed by its procedures, and anything stored around the booth before work starts.
What determines whether ductwork is removed or left?
The new layout, condition of the duct, fan reuse plans, roof or wall penetrations, and the facility's desired end point determine that decision.
Can removal work include a paint mixing room or prep station?
It can, if those components are included in the scope and their utilities, exhaust, and access requirements are reviewed.
What access details are most important?
Door sizes, aisle turns, overhead obstructions, lift availability, dock position, and staging space are key details for moving removed components.