Paint Booth Relocation for Louisiana Coastal and Inland Plants
In Louisiana, salt air, humidity and storms leave their mark on booth panels, duct, stacks and hardware long before a booth is moved. Double D Mechanical relocates paint booths for Louisiana facilities, sorting what is sound enough to reuse and planning roof and stack work around the weather.
Discuss your installationWhat Salt and Humidity Do to Booth Parts
Panel seams, fasteners, duct joints and stack bases are where corrosion usually starts. Rust can weaken panels at the bottom edge, seize bolts and eat through duct at low points where water sits. Corrosion is easier to spot during a careful teardown than after the booth is back up.
Reuse, Repair or Replace
Each major component is sorted during teardown so new parts can be ordered while the old booth is still coming down.
- Panels: reuse, repair seams or replace lower sections
- Fasteners: replace rusted hardware rather than reuse it
- Duct and stacks: inspect joints and low points for thinning
- Fans and motors: check bearings and housings for corrosion
Shipyard, Fabrication and Hangar Activity
The Saronic shipyard expansion in Franklin, Quality Companies' alloy fabrication expansion in Jeanerette and Youngsville and the aircraft paint hangar at Chennault International Airport in Lake Charles show active coating and fabrication work along the Louisiana coast. Plants from Lake Charles and Acadiana to Baton Rouge, New Orleans and Shreveport move and resize finishing equipment as that work grows.
Weather Windows for Roof and Stack Work
Stack and make-up air openings leave a building exposed while they are open. Roof work is planned with temporary covers, and on the coast it is scheduled with storm season in mind so openings are never left unprotected overnight.
Planning a booth or oven project in Louisiana
Crews mobilize from Houston; Louisiana is roughly 250 miles away, so equipment, panels and tooling are staged and shipped ahead of the install crew.
Manufacturing in Louisiana is concentrated around Baton Rouge, New Orleans, Shreveport, and Lafayette. The sectors most likely to be specifying spray booths, blast rooms, powder systems and cure ovens there include petrochemical and refining, shipbuilding and marine fabrication, oilfield equipment, and industrial coatings.
High humidity most of the year means intake air drying, booth heater sizing for spray and bake, and corrosion-resistant hardware matter more than usual.
Frequently asked questions
Can rusted booth duct be reused after a move?
Lightly surface-rusted duct may be reusable after inspection. Duct thinned or holed at joints and low points should be replaced.
Should booth fasteners be replaced during relocation?
In coastal plants, generally yes. Rusted bolts lose strength and are hard to remove later, and new hardware is a small cost compared to reassembly labor.
How are roof openings protected if a storm comes mid-project?
Openings are covered with temporary weatherproof closures at the end of each work period, and roof work is scheduled around forecasts.
Does the booth's fire suppression move with it?
The system is disconnected and reinstalled by the fire protection contractor, coordinated with the booth reassembly schedule.
What should a Louisiana plant send before planning a move?
Photos of the booth, plenum, duct, stacks and fan, close-ups of any visible rust, the new layout and the window available for the move.