Paint booth relocation for power transformer production
Power transformer finishing areas may handle tanks, radiators, covers, frames, cabinets and heavy assemblies with complex shapes. Double D Mechanical relocates paint booths with attention to crane and cart movement, exhaust and make-up air, utility reconnection, clearance around large components and access for maintenance.
Discuss your installationMoving heavy transformer assemblies
The new booth location should support tank and radiator movement from fabrication or prep into coating and out to staging. Planning should review crane reach, hook height, transfer carts, door clearance, turning space and room for coating around ribs and accessories.
Air paths around complex shapes
Transformer parts can have fins, pockets and edges that need consistent booth airflow. Relocation planning should review exhaust openings, duct routes, fan placement, make-up air, filters and nearby building openings that may affect air balance.
Utility routes around crane bays
Power, controls, compressed air, gas if present and ductwork should be routed with crane travel, bus duct, lighting and structural steel in mind. Connections should remain reachable without placing service work in a blocked production lane.
Reassembly and component condition
Before dismantling, document booth panels, doors, light fixtures, fans, ducts, seals and fasteners. Heavy industrial use can reveal worn parts that should be addressed while the booth is apart.
Transformer shop planning details
Have tank and accessory dimensions, handling equipment information, booth drawings, photos of current connections, utility locations, proposed floor plans and roof or wall route information ready for review.
Frequently asked questions
What clearance matters most for transformer booth relocation?
Door height, crane hook height, tank width, cart paths, radiator handling and room for applicators around complex surfaces should all be checked.
Can existing fans be reused after relocation?
Existing fans may be reused if their condition and the new duct route support the intended exhaust arrangement.
Why are crane paths important?
Ductwork, utilities and booth structure must not conflict with crane travel, lifted loads or the space needed to safely position heavy assemblies.
What should be labeled before the booth is moved?
Label wiring, controls, duct sections, compressed air, gas if used, panels and any hardware that must return to a specific location.
How should maintenance access be handled?
Leave room to change filters, service fans, inspect ducts, reach lights, open doors and access disconnects or valves.