Paint booth relocation for metal fabrication shops
Metal fabrication shops may finish weldments, frames, brackets, enclosures, guards and custom assemblies that change in size from job to job. Double D Mechanical relocates paint booths with attention to practical floor flow, exhaust and make-up air, compressed air and electrical connections, part clearance, trade sequencing and service access.
Discuss your installationFitting the booth to changing part sizes
A relocated booth should handle the shop's common workpieces without choking forklift lanes or staging space. Planning should consider maximum part envelope, cart sizes, crane or jib coverage, door approach and room for coating on all sides.
Air system changes in the new spot
Moving the booth changes duct length, fan location, replacement air path and the effect on surrounding shop pressure. Double D Mechanical reviews exhaust routes, make-up air, filter access, supports and wall or roof penetrations before reconnection.
Utility routing through active fabrication
Electrical, controls, compressed air and gas if used must be routed around welding areas, material racks, overhead doors and equipment. Connections should be protected but still accessible for operators and maintenance staff.
Dismantle and reassembly planning
Before the booth is moved, panels, ducts, wiring, fans, doors, lights and hardware should be documented. Staging space for removed components should be identified so parts are not mixed with shop material or blocked by production.
Site visit preparation for fabricators
Have booth drawings if available, current and proposed floor plans, photos of duct and utility connections, part size ranges, ceiling heights and notes on aisles or equipment that must remain usable.
Frequently asked questions
What should a metal fabrication shop measure before relocating a booth?
Measure common and maximum part sizes, booth footprint, door clearance, aisle width, ceiling height, duct routes and available service space.
Can booth relocation be planned around active shop work?
It can be sequenced with the facility team, but staging, utility shutoffs, equipment movement and nearby production conflicts should be reviewed early.
What happens to the existing exhaust duct?
Existing ductwork should be inspected for condition and fit, then evaluated against the new fan location, route and discharge point.
Why is make-up air part of a booth move?
When exhaust moves air out of the building, replacement air affects booth performance, shop pressure and comfort near the finish area.
What photos help with estimating a relocation?
Photos of the booth interior and exterior, ductwork, fans, roof or wall penetrations, electrical panels, air drops and surrounding production space are useful.