Side Downdraft Paint Booth Relocation
Side downdraft paint booth relocation has to protect the booth's side exhaust arrangement while fitting the equipment into a new bay. Double D Mechanical plans disassembly, setting, ductwork, make-up air, utilities, lighting, and service access so the booth can support finishing work without crowding operators or maintenance points.
Discuss your installationSide Plenum Clearance
Side downdraft booths need room along the lower side exhaust areas for filters, plenums, panels, and service doors. The receiving location should leave enough working space beside the booth, not just at the entry and exit.
Roof And Wall Routing Choices
Exhaust ductwork may need to rise from side plenums, cross overhead, or turn toward a wall or roof discharge. The routing plan should account for structure, cranes, lights, sprinklers, other trades, and access to dampers or cleanout points.
Operator Movement Around The Booth
The relocated booth should allow safe movement around doors, platforms, carts, racks, and the workpiece. For large parts or fleet work, side clearance can be just as important as end clearance because operators need room to inspect and move between process steps.
Pre-Move Documentation
Photos of side plenums, filter frames, door hardware, lighting, controls, and duct connections help guide the relocation. Current drawings, utility data, ceiling dimensions, and the proposed booth orientation should be ready before the walkthrough.
Frequently asked questions
What is the main concern when moving a side downdraft booth?
The side exhaust areas need enough clearance for airflow, filters, duct connections, and maintenance after the booth is set in the new space.
Can side exhaust ductwork be rerouted during relocation?
Yes, if the new path supports the booth airflow and allows proper fan access, structural support, and discharge routing.
What areas should be measured before the move?
Measure the booth footprint, side service zones, door clearance, ceiling height, overhead conflicts, duct route, and travel path for the largest part or vehicle.
Will lighting and controls need to be disconnected?
Relocation typically requires disconnecting and reconnecting lighting circuits, fan controls, interlocks, and other utilities tied to the booth.