Automotive Booth Exhaust System Installation
An automotive booth exhaust system has to pull air through the booth as intended while fitting the building, roof, utilities and service routines around it. Double D Mechanical coordinates fans, ductwork, filter sections, discharge paths, make-up air and controls for refinish and fleet paint areas.
Discuss your installationCapture From The Booth Interior
The exhaust system has to match the booth style, whether air leaves through rear plenums, side sections, floor openings or another designed path. Installation should keep filters seated and accessible, avoid blocked exhaust chambers and leave enough clearance for technicians to service the system without disrupting the booth interior.
Duct Paths To The Outside
Duct routing should be planned before the booth is set. Roof structure, wall locations, existing HVAC, lighting, sprinklers and overhead doors can all influence the path. Fan placement and discharge orientation should also leave room for motor, belt, damper and stack service.
Replacement Air And Pressure Control
Exhaust cannot be planned in isolation. The make-up air unit, building openings and nearby shop zones affect booth balance and operator comfort. Coordinating exhaust with replacement air helps reduce drafts, pressure swings and doors that become difficult to open during booth operation.
Field Information That Helps
For a useful review, gather booth drawings, fan information if available, ceiling and roof measurements, utility locations and photos of the intended duct route. A simple sketch of vehicle flow and adjacent prep or mixing areas also helps identify access concerns.
Frequently asked questions
What parts make up a booth exhaust system?
Common parts include exhaust plenums or chambers, filters, ductwork, fans, dampers, discharge components, controls and service access points.
Why should exhaust routing be planned early?
Duct and fan locations can conflict with structure, roof openings, lighting, sprinklers, utilities and future maintenance access.
How does make-up air relate to exhaust?
The exhaust system removes air from the building, so replacement air helps maintain booth airflow and pressure balance.
What should be inspected in an existing booth exhaust system?
Useful review points include filter access, duct condition, fan placement, motor access, discharge path, control wiring and make-up air coordination.