Switchgear Enclosure Finishing in Louisiana
Electrical switchgear enclosure finishing in Louisiana has to manage humidity, heavy fabricated parts, clean coating flow and utility-intensive equipment. Double D Mechanical installs, relocates and services paint booths, powder coating systems, ovens, washers, exhaust, make-up air and related utility connections.
Discuss your installationMoisture Control Before Coating
Humid air can complicate pretreatment, powder application, flash time and cure consistency. Intake location, filtration, make-up air delivery and separation from dirty fabrication work should be planned with the coating process in mind.
Cabinets, Doors and Small Parts Together
Switchgear enclosure production often mixes large cabinet bodies with doors, covers, brackets and panels. Racks, hooks, cart spacing and touch-up areas should support that mix without crowding booth openings or oven doors.
Louisiana Fabrication and Paint Activity
Louisiana activity includes the Saronic shipyard expansion in Franklin, Quality Companies alloy fabrication expansion in Jeanerette and Youngsville, and the Chennault International Airport aircraft paint hangar in Lake Charles. These records reflect heavy fabrication and finishing needs across the state.
Coordinating Roof and Utility Work
Exhaust stacks, make-up air units, gas piping, electrical feeds, compressed air, drains and controls need to be sequenced with roofing, structural, fire protection and production work. Early coordination helps keep installation from colliding with daily plant movement.
Planning a booth or oven project in Louisiana
Crews mobilize from Houston; Louisiana is roughly 250 miles away, so equipment, panels and tooling are staged and shipped ahead of the install crew.
Manufacturing in Louisiana is concentrated around Baton Rouge, New Orleans, Shreveport, and Lafayette. The sectors most likely to be specifying spray booths, blast rooms, powder systems and cure ovens there include petrochemical and refining, shipbuilding and marine fabrication, oilfield equipment, and industrial coatings.
High humidity most of the year means intake air drying, booth heater sizing for spray and bake, and corrosion-resistant hardware matter more than usual.
Frequently asked questions
What should be ready before planning an enclosure line?
Bring part sizes, rack concepts, coating requirements, throughput goals, building drawings, utility locations and any quality concerns from the current process.
Can a washer be added ahead of an existing powder booth?
Sometimes. The review should include floor space, drains, water service, chemical handling, drying capacity and the path from washer to booth.
Why keep clean and raw parts separated?
Separating those paths helps protect adhesion and appearance by reducing dust, oils, handling damage and cross traffic near freshly coated parts.
What is checked during service on enclosure finishing equipment?
Common checks include filters, fans, belts, burners, sensors, dampers, airflow, oven temperature, washer pumps and visible duct or panel damage.