Large equipment paint booths for heavy equipment and agriculture
Heavy equipment and agricultural finishing can involve large frames, cabs, buckets, booms, tanks, implements and attachments with varied shapes and handling needs. Double D Mechanical installs, relocates and services large equipment paint booths with planning for part movement, ventilation, exhaust, make-up air, utility connections and maintenance access.
Discuss your installationSpace for Implements and Assemblies
Large equipment booths should be planned around the biggest workpieces and the fixtures that carry them. Door height, booth width, part swing, crane reach, forklift aisles and staging room all shape how well the booth supports daily production.
Air Paths Around Complex Geometry
Frames, buckets, booms and cabs can block or redirect airflow inside the booth. Exhaust and make-up air placement should be reviewed around real part profiles so coating work is not fighting stagnant pockets or unwanted drafts.
Utility Connections Near Fabrication Flow
Electrical service, compressed air, controls, heat, exhaust duct and make-up air equipment need routes that fit around welding, prep, wash, assembly and cure areas. Installation sequencing should protect the plant's main movement paths.
Site Details for Better Planning
Prepare part dimensions, handling methods, proposed location options, ceiling and door clearances, utility locations, roof or wall exhaust paths, nearby equipment and any areas that must stay usable during installation.
Frequently asked questions
What parts should be considered for large booth sizing?
Include cabs, frames, tanks, buckets, booms, implements, attachments and any racks or carts used to move them through the paint area.
Why review airflow with actual part shapes?
Irregular equipment shapes can shield surfaces and create stagnant areas, so ventilation planning should reflect the parts that operators actually coat.
Can an existing large equipment booth be relocated?
Relocation can be reviewed by checking booth condition, panel layout, duct, fans, controls, utility disconnects, rigging route and the new location.
What access is needed for maintenance?
Maintenance access should remain for filters, fans, lights, burners, controls, dampers, duct service points and make-up air equipment.