Relocating a Batch Cure Oven in Ohio
Cure ovens are panel structures, and most can be taken apart and moved. Doing it without damaging insulated panels or losing track of duct and burner connections takes planning. Ohio plants moving a batch oven to a new building or a different bay need the gas, electrical and exhaust connections redone at the new location. Double D relocates batch cure ovens and gets them back to temperature.
Discuss your installationDisconnecting gas, power and exhaust
The gas train is shut off and disconnected, electrical service locked out, and the exhaust stack removed. Connections are documented so they can be redone correctly at the new site.
Taking panels apart without damage
Insulated panels are marked, unbolted and stacked with protection so their skins and seals do not get damaged. Heater boxes, fans and ductwork are removed and transported carefully.
- Mark panels by wall and position
- Protect panel edges and seals
- Remove heater box, fans and duct
- Inspect insulation for damage
Reassembly and new connections
At the new site, panels go up on a level floor, seams are sealed, and the heater box and recirculation duct are reinstalled. Gas piping, electrical and exhaust are connected to the new building.
Proving the oven before production
After reassembly, burner safety checks, purge timing and temperature profiling confirm the oven runs as it should. A full profile with parts verifies cure.
Planning a booth or oven project in Ohio
Crews mobilize from Houston; Ohio is roughly 1,000 miles away, so equipment, panels and tooling are staged and shipped ahead of the install crew.
Manufacturing in Ohio is concentrated around Columbus, Cleveland, Cincinnati, Dayton, and Toledo. The sectors most likely to be specifying spray booths, blast rooms, powder systems and cure ovens there include automotive assembly and suppliers, aerospace, steel and metal fabrication, and semiconductors.
Cold winters mean make-up air heaters are sized for sub-freezing intake, and booth or oven placement has to account for frost lines, snow loads on roof penetrations and winter slab work.
Frequently asked questions
Can a cure oven be moved without replacing panels?
Usually, if panels are carefully disassembled and protected. Damaged panels can be replaced individually.
Does the new building need a gas line?
Yes, sized for the oven burner. Check capacity at the new location.
Can the oven be resized during the move?
Sometimes. Panels can sometimes be added or removed, with burner and airflow checks.
What checks happen after relocation?
Burner safety, purge, exhaust operation and temperature profiling.
Can you move our booth too?
Yes. Moving booth and oven together lets us lay out the new space as one flow.