Automotive Refinish Booths for Pennsylvania Body Shops
Pennsylvania body shops often occupy older buildings with low ceilings, thick floors and utilities that have been added onto for decades. Installing or replacing a refinish booth in one of them takes careful planning, and Double D Mechanical handles that planning along with the installation, relocation and service of the booth itself.
Discuss your installationFitting Into Older Buildings
Older buildings bring challenges for refinish booths.
- Low ceilings that limit cabin and plenum height
- Unknown conditions under the slab for pit work
- Roof structure that may not carry a make-up air unit
- Limited gas and electrical capacity
Fleet Vehicles in Western Pennsylvania
Industrial investment like GE Vernova's breaker and switchgear expansion at Charleroi and Rostraver supports service fleets and company vehicles. Body shops serving those fleets need booths that keep cycle times short.
Replacing an Old Booth
Replacement projects reuse what they can: sometimes the pit, stack, gas line or electrical service. We assess the old booth's systems before the new one is ordered, then remove the old booth and install the new one with minimal downtime.
January Bake Cycles
Pennsylvania winters push burners hard. Pre-winter service, adequate gas pressure and good door seals keep bake cycles on time.
Planning a booth or oven project in Pennsylvania
Crews mobilize from Houston; Pennsylvania is roughly 1,350 miles away, so equipment, panels and tooling are staged and shipped ahead of the install crew.
Manufacturing in Pennsylvania is concentrated around Philadelphia, Pittsburgh, Harrisburg, Allentown, and Erie. The sectors most likely to be specifying spray booths, blast rooms, powder systems and cure ovens there include steel and metals, heavy machinery, rail equipment, and defense.
Cold winters mean make-up air heaters are sized for sub-freezing intake, and booth or oven placement has to account for frost lines, snow loads on roof penetrations and winter slab work.
Frequently asked questions
Can a new booth reuse our old pit?
If the pit is sound and sized for the new booth. We inspect it before the new booth is designed.
What if our ceiling is too low?
Some booths are designed for limited height. We measure clear height to obstructions before recommending one.
How long does a booth replacement take?
It depends on the scope. We plan replacements to keep downtime as short as practical.
Do you service older booths?
Yes. We service burners, fans, controls and doors on refinish booths of any age.