Wisconsin Oven conveyor cure oven installation and relocation
Wisconsin Oven conveyor cure ovens are part of finishing lines where coated parts travel through heated zones at controlled spacing. Double D Mechanical plans installation, relocation and service around conveyor alignment, part envelope, oven section joints, burner and fan access, exhaust, make-up air, gas, electrical service and controls.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Conveyor Path Through Heat Zones
The oven layout should match conveyor centerline, elevation, carrier pitch and the largest part that will pass through the openings. Turns, inclines, rack swing and nearby transfers should be reviewed before oven sections are set.
Section Joints And Line Interfaces
Oven sections, vestibules, conveyor slots, insulation joints and access panels need careful alignment. The work should be sequenced with conveyor installers, electrical work, gas piping and duct routing.
Fans, Exhaust And Make-Up Air
Circulation fans, exhaust fans and replacement air affect oven performance and surrounding rooms. Fan orientation, stack location, roof work and building pressure should be considered with the rest of the finishing system.
Preparation Before Shutdown Work
For a relocation or major service event, document the oven line direction, section sequence, control connections, utility tie-ins and clearance limits. Production should also identify how parts will be staged before the line returns to operation.
- Confirm part envelope, rack swing and conveyor height.
- Map all gas, electrical, control and exhaust connections.
- Reserve maintenance space at burners, fans and access doors.
Frequently asked questions
What should be checked at conveyor openings?
Check part height, part width, carrier swing, hook clearance, conveyor elevation and the location of vestibules or seals.
Can conveyor cure ovens be installed in phases?
Phasing depends on the line layout, production schedule, utility readiness and how oven sections connect to conveyors and exhaust systems.
Why coordinate with other trades early?
Gas piping, electrical feeds, controls, ductwork, roof penetrations, conveyors and guards all compete for the same space around the oven.
What documents are useful before a site visit?
Oven drawings, conveyor drawings, utility information, part data, photos and a sketch of the intended line layout are useful.