Wheelabrator Equipment for Fabricated Metal Parts
Fabricated metal parts can range from small brackets to welded assemblies, so the finishing area has to support changing shapes without losing control of air movement, handling and service access. Double D Mechanical helps install, relocate and service Wheelabrator blast equipment around racks, media recovery, exhaust, make-up air, powder or liquid coating flow and plant utilities.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Part Mix And Handling Method
The right layout depends on whether parts are hung, carted, set on fixtures or moved by forklift. Wheelabrator blast equipment should be positioned around the largest part envelope, expected rack density, operator reach and the path from fabrication into finishing.
From Surface Prep To Finish
Fabricated parts often need masking, cleaning, blasting, coating and curing or drying in a tight sequence. The equipment arrangement should keep raw parts, cleaned parts and finished parts from crossing paths in ways that add handling or contamination risk.
- List the largest part, smallest repeat part and normal rack configuration.
- Identify coating changes that affect booth cleanup or staging.
- Keep inspection and touch-up space near the finishing route.
Mechanical Connections Across The Cell
Blast booths, paint booths, powder booths and ovens each place different demands on exhaust, compressed air, power, make-up air and heat. Coordinating those connections early helps avoid conflicts with roof structure, utility racks, cranes, conveyors and adjacent production equipment.
Access For Ongoing Service
A finishing cell for mixed metal parts should leave room for filter changes, media cleanup, fan service, lighting access, control work and oven panel access where applicable. Service clearance is easier to protect when it is part of the layout from the start.
Frequently asked questions
What part information should be ready before a visit?
Bring part size ranges, rack or fixture details, coating process notes, utility locations, bay dimensions and photos of current production flow.
How does part variety affect booth planning?
Part variety affects rack spacing, operator access, airflow, staging and the amount of room needed for masking and inspection.
Can a finishing cell include both blast and powder equipment?
Yes, with proper separation, exhaust, recovery, curing and clean staging so abrasive dust does not interfere with coating.
What is important during equipment relocation?
Panel condition, anchors, utilities, ductwork, reclaim equipment, floor condition and access in the new location should all be reviewed.