Trimac Industrial Systems for Automotive Bodies and Parts
Automotive bodies, panels, frames and separate metal parts need controlled finishing areas that support prep, coating, cure and inspection without disrupting assembly flow. Trimac Industrial Systems cure ovens can support liquid or powder operations where airflow, heat, exhaust, replacement air and utility routing all affect production. Double D Mechanical installs, relocates and services the mechanical systems around these finishing areas.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Bodies, Panels And Part Racks
Automotive finishing layouts may handle full body sections, service panels, brackets, wheels or production parts. The equipment approach should consider door openings, rack height, part swing, operator reach and the clearance needed for carts or lift equipment.
Prep Stations Into Finish Work
Sanding, cleaning, masking, coating, cure and cool-down areas should be sequenced so clean parts do not cross dusty prep traffic. Booths, ovens and staging lanes need enough space for inspection and rework without clogging the main production route.
Airflow, Heat And Exhaust Paths
Trimac oven and booth installations require coordination of heat sources, exhaust, make-up air, electrical feeds and controls. Roof structure, duct runs, fan locations and adjacent ventilation should be reviewed before equipment is set.
- Measure body sections, panels, racks, carts and lift clearances.
- Map prep, mask, coat, cure, cool, inspect and assembly flow.
- Confirm gas, electrical, compressed air, exhaust and roof access.
Move Or Service Readiness
For relocation or repair, review oven section sizes, booth condition, fan access, duct connections, utility isolation and control wiring. The work sequence should protect nearby production areas and preserve access to filters, burners, lights and doors after startup.
Frequently asked questions
What automotive parts should be considered in layout planning?
Body sections, panels, brackets, racks, carts, fixtures and the largest part expected in the booth or oven should be included.
Why separate prep from coating?
Sanding dust and cleaning work can contaminate prepared parts, so the flow should keep clean coating areas distinct from prep traffic.
What does make-up air support in a finishing area?
Make-up air helps replace exhausted air so booths and ovens can operate without drawing heavily from nearby production spaces.
Can Trimac oven equipment be moved?
Relocation depends on access, section sizes, equipment condition, duct routes, control wiring and available utilities in the new area.
What information helps Double D Mechanical before visiting?
Photos, equipment drawings, part dimensions, utility locations, roof access and notes on current production flow are helpful.