Therma-Tron-X for HVAC Units and Fans
HVAC cabinet and fan production includes panels, housings, frames, guards and access doors that are often coated before final assembly. Therma-Tron-X powder coating lines and conveyor cure ovens can fit this style of repeated sheet metal finishing. Double D Mechanical installs, relocates and services the powder booth, oven, exhaust, make-up air and utility connections that support HVAC equipment manufacturing.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Cabinet Panels And Fan Housings
HVAC work can include flat panels, formed cabinet sections, fan shrouds, guards and welded frames. The equipment layout should account for part depth, hanger points, sharp edges, perforations and the clearance needed through booth openings and oven entries.
Assembly Flow After Coating
Coated parts should move toward gasket, insulation, motor, coil and hardware assembly without crossing raw fabrication traffic. Space for masking, cleaning, inspection, cooling and touch-up work should be placed where it supports the production sequence instead of crowding the unload end.
Air Replacement And Cure Loads
Powder booths, exhaust systems and cure ovens place demands on replacement air, heat, compressed air and electrical service. Duct routes, discharge locations, burner or heating connections and control wiring should be coordinated before setting large oven and booth sections.
- Measure the largest cabinet section, guard and fan housing.
- Confirm load heights, rack spacing and conveyor direction.
- Locate gas, electrical, compressed air, exhaust and make-up air paths.
Access Around Filters And Drives
Filters, collector modules, fan drives, oven panels, doors and control cabinets need access after fixtures and parts carts are in place. For a relocation, review panel condition, conveyor alignment, section weights, duct reuse and utility routing before the move is sequenced.
Frequently asked questions
What HVAC parts should be considered during layout?
Cabinet panels, fan housings, guards, frames, doors and formed covers should be measured because each can affect hanging, clearance and airflow.
How does airflow affect HVAC cabinet coating?
Dense racks and broad panels can shadow airflow, so booth exhaust, replacement air and part spacing should be reviewed together.
What trades need coordination around an oven installation?
Mechanical, electrical, fire protection, roofing, controls and production rigging may all affect when the oven, duct and utilities can be set.
What makes service access difficult on HVAC lines?
Stored panels, carts, fixtures and packaging can block filters, fans, oven doors and control cabinets if maintenance space is not reserved.
What should be gathered before a site visit?
Bring part dimensions, production flow notes, current utility locations, photos, roof access information and any planned equipment moves.