Spray-Tech/Junair Automotive Paint Booth Installation
A Spray-Tech/Junair automotive paint booth has to work with vehicle movement, prep space, masking, paint mixing, curing, and final inspection. Double D Mechanical supports installation by setting the booth, connecting mechanical systems, and coordinating airflow, exhaust, and utility needs around the shop layout.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Vehicle Flow Through the Shop
Automotive booth placement affects how vehicles move from repair to prep, spray, cure, and detail. Door alignment, approach space, lift locations, and nearby stalls should be reviewed so technicians are not fighting tight turns or blocked work areas.
Downdraft and Semi-Downdraft Needs
Automotive refinish booths often depend on controlled intake air, exhaust paths, and filter loading. Installation details such as plenum alignment, pit or floor interface, fan setup, and make-up air connections influence booth balance and finish consistency.
Connections Beyond the Booth Shell
The booth shell is only part of the installation. Mechanical work may involve ductwork, compressed air drops, gas piping for heated air systems, exhaust fans, and coordination with lighting, controls, and fire suppression trades.
Preparing the Bay
Before installation, the shop should confirm the booth footprint, vehicle clearances, floor condition, access route, utility locations, and any work that must be completed by other trades. Good preparation helps reduce disruption to repair throughput.
Frequently asked questions
What should an auto shop measure before a booth installation?
Measure vehicle approach space, door openings, ceiling height, booth footprint, floor condition, and the clear area needed for doors, filters, and service panels.
Does booth location affect paint quality?
Yes. Nearby doors, fans, prep areas, and building pressure can disturb airflow if the booth and make-up air system are not planned together.
What utilities are commonly needed?
Automotive booths commonly require electrical power, compressed air, exhaust ductwork, and, for heated systems, a gas or heat connection.
Can installation happen while the shop is operating?
Some surrounding work may be sequenced around operations, but equipment setting, utility tie-ins, roof penetrations, and shutdowns need careful scheduling.
Why is maintenance access important in a refinish booth?
Technicians need room to change filters, clean surfaces, service lights, inspect fans, and reach controls without moving vehicles or dismantling nearby fixtures.