Rohner open face paint booth installation and relocation
Rohner open face paint booths are used for accessible spray finishing on fabricated parts, equipment components and industrial assemblies. Double D Mechanical plans installation, relocation and connections around part loading, capture airflow, exhaust ducting, replacement air, utilities and maintenance access.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Open Front Loading Space
The booth face should remain clear enough for parts, carts, forklifts or fixtures to enter the work area. The surrounding layout should allow operators to spray from practical positions without placing stands, racks or storage in the capture path.
Filter Bank and Fan Access
Open face booths depend on the filter bank and exhaust fan arrangement to pull air away from the operator and workpiece. Service access to filters, fan sections, duct connections and controls should be planned before nearby equipment is fixed in place.
Building Air and Utility Routing
Exhausted air must be replaced in a way that supports booth performance and shop comfort. Electrical service, compressed air, lighting, controls and make-up air should be coordinated with doors, cranes, columns and other exhaust equipment.
Site Notes That Speed Planning
Before a walkthrough, gather part dimensions, handling methods, proposed booth location, utility locations, photos and any available drawings. For relocation, document panel order, filter layout, fan position, duct routes and control connections.
- Show how the largest part reaches the booth opening.
- Identify nearby air movement sources, doors and exhaust equipment.
- Keep filter changes and fan service clear in the proposed layout.
Frequently asked questions
What is important for an open face booth location?
The location should support part loading, operator access, capture airflow, exhaust routing, replacement air and filter service.
Can an open face booth support large parts?
It can when the opening, work area, handling method and airflow are planned around the actual part size.
What utilities should be identified?
Electrical service, lighting, compressed air, controls and any make-up air or interlock connections should be identified.
What should be documented before a booth move?
Panels, filters, fans, ductwork, controls, lights, utility entry points and the original booth orientation should be documented.