Rohner for Fabricated Metal Parts
Fabricated metal part finishing can involve brackets, weldments, panels, guards, frames, housings and repeat components moving through prep, paint, powder or cure. Rohner equipment in this setting can include open-face booths, powder coating booths, powder coating lines, cure ovens, blast rooms, make-up air and exhaust systems. Double D Mechanical installs, relocates and services the booth, oven, air, exhaust and utility connections that help the finishing area support production flow.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Part Envelope And Rack Strategy
The useful layout starts with the real part envelope, including hooks, racks, carts, stands and fork pockets. Small parts may need dense hanging, while larger weldments need wider aisles and clear operator reach. Booth and oven openings should match the loaded rack, not just the bare part.
Preparation To Finish Routing
Fabricated parts may move through grinding, wash, blast, mask, liquid paint, powder coating, cure and inspection. The equipment arrangement should reduce backtracking and keep cleaned parts away from raw fabrication traffic. Utility drops, ducts and control panels should support that flow without becoming obstacles.
Shared Air And Utility Loads
A finishing department may have several exhaust points, ovens and prep areas operating together. Make-up air, fan discharge, compressed air, electrical service and heat connections should be reviewed together before roof openings, pads or final equipment positions are set.
Service Planning For Mixed Parts
Part variety can hide service points if racks and carts are parked too close to equipment. Keep filters, lights, fans, burners, powder recovery components, doors and controls reachable. Existing booths or ovens should be inspected for panel condition, seals, ducts and utility reach before relocation.
Frequently asked questions
What details help plan fabricated metal part finishing?
Part sizes, rack dimensions, coating type, process order, handling method, utility locations and expected staging needs are useful before a site visit.
Can fabricated parts use both liquid and powder equipment?
Yes. The best fit depends on coating requirements, part geometry, cure needs, production flow and how the plant handles masking and inspection.
Why include racks and carts in measurements?
Racks and carts define the real clearance needed for booth doors, oven loading, operator reach and turns through the finishing area.
What utility items should be reviewed early?
Review exhaust routing, make-up air, electrical service, compressed air, control wiring and heat connections for ovens or heated air.
What matters during a booth or oven relocation?
Condition of panels, doors, seals, lights, fans, ducts, controls, utility isolation, rigging path and service clearance in the new location all matter.