Pauli Systems Paint Booth Exhaust Ductwork
Pauli Systems enclosures used for blasting or finishing need exhaust and dust collection ductwork that fits the building and the process. Routing should support steady air movement, practical service access, collector performance, roof or wall exits, and replacement air so the enclosure can operate without disturbing nearby production areas.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Routing From Enclosure to Collector
Duct routing should be planned around the enclosure outlet, collector inlet, structural steel, cranes, roof framing, doors, and active production aisles. Short, direct routing is useful, but service access and building constraints often drive the final path. Transitions and turns should be reviewed for clean installation and maintenance.
Fan, Collector, and Service Reach
Exhaust and dust collection equipment must remain accessible after installation. Filter changes, motor service, damper adjustment, cleanout points, and fan inspection should not require major production disruption. Placement should also consider noise, discharge direction, and clearance around adjacent equipment.
Replacement Air and Building Pressure
Removing air from a booth or blast enclosure changes the building environment. If replacement air is not considered, doors may pull hard, dust may migrate, or other exhaust systems may behave differently. Make-up air equipment, louvers, nearby HVAC, and open bay conditions should be reviewed together.
Field Measurements to Capture
Accurate field information helps prevent duct conflicts during installation.
- Ceiling height, roof structure, and crane coverage
- Enclosure outlet size and collector location options
- Nearby utilities, sprinklers, lights, and bus duct
- Roof or wall exit preferences and access limits
- Existing exhaust systems that run at the same time
Frequently asked questions
Can exhaust ductwork serve both blast and finishing equipment?
Each process needs to be reviewed on its own. Air volume, dust loading, filter type, material compatibility, and operating schedule can make shared routing impractical.
Why is make-up air part of a ductwork discussion?
Exhaust ductwork removes air from the building. Replacement air affects booth balance, door behavior, dust control, and comfort near the work area.
What access is needed around a dust collector?
Maintenance teams need space for filter service, fan and motor access, cleanout points, controls, and safe approach with the tools or lift equipment used in the plant.
What should be ready before ductwork planning?
Have enclosure drawings if available, photos of the route, roof or wall access details, collector information, ceiling measurements, and a list of nearby utilities.