Pauli Systems Oilfield Equipment Finishing
Oilfield skids, frames, housings and welded components need rugged surface preparation and coating areas that can handle varied shapes and heavy handling. Double D Mechanical installs, relocates and services Pauli Systems blast rooms, abrasive blast booths, media recovery equipment, paint booth connections, exhaust systems, make-up air and supporting utilities for these finishing operations.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Skid And Frame Movement
Oilfield equipment often arrives as irregular weldments with lifting lugs, base rails, guards and protruding connections. Booth and blast room planning should confirm door clearances, turning space, cart or forklift paths and safe access around the workpiece once it is inside the enclosure.
Abrasive Prep Before Protective Coating
Blast rooms for oilfield components need reliable media movement, dust collection and cleanup access because surface preparation often sets the pace for coating. Reclaim equipment, compressed air piping, separators and collection points should be positioned so operators can keep production moving without blocking the next load.
Exhaust, Heat And Replacement Air
Large weldments can interrupt airflow and create uneven capture if exhaust plenums, supply air and part placement are not considered together. Make-up air units, booth heaters, exhaust fans and ductwork need coordinated routes that leave service access and avoid conflicts with cranes, building columns and utility racks.
Relocation And Shutdown Planning
Moving an existing finishing cell requires a careful look at what can be reused, what needs repair and what must change for the new production path. Useful planning details include equipment photos, panel counts, duct sizes, control locations, utility disconnect points and the desired restart sequence.
Frequently asked questions
What should be measured before an oilfield equipment finishing layout is reviewed?
Measure the largest skid or housing, lift height, turning radius, door openings, ceiling restrictions and the staging space needed before and after blasting or coating.
Do blast media recovery systems need special access?
They need practical access for inspection, debris removal, wear parts and collection points. The exact access needs depend on the recovery style and how much media the operation moves.
Can paint booth exhaust be routed through an existing roof opening?
Sometimes, but the route needs to be checked against fan requirements, duct size, structural limits, roof conditions and other building systems.
What trades usually need coordination during installation?
Mechanical, electrical, fire protection, controls, concrete, roofing and rigging may all need sequencing depending on the equipment and building conditions.
What information helps with a service visit?
Have equipment model information if available, photos of the issue, fan and control locations, filter condition, utility shutoff points and notes about when the problem occurs.