Pauli Systems abrasive blast booth installation and service
Pauli Systems abrasive blast booths support contained surface preparation for fabricated metal, vehicle parts, aerospace components and other work that needs consistent blast access before coating or inspection. Double D Mechanical installs, relocates and services blast booth systems with attention to air movement, dust collection, media recovery, compressed air and production access.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Booth Placement In The Workstream
A blast booth should sit where parts can enter, be cleaned and move to the next step without cross traffic or awkward staging. The booth opening, operator access, hose reach and material handling path should be reviewed together, especially when blasting is upstream of paint or powder coating.
Collector Location And Duct Runs
Dust collector placement affects booth performance and service labor. Duct length, elbows, blast dust loading, access doors and fan service clearance should be planned before anchoring equipment or cutting wall and roof openings.
- Leave room for filter access and dust removal.
- Coordinate duct support with structure and other trades.
- Avoid routing that blocks overhead doors or lift paths.
Abrasive Flow And Cleanup
Media recovery equipment can reduce manual cleanup when the floor, hopper or vacuum layout matches how operators work. Reclaim components should be reachable for service, and abrasive loading points should not interfere with part movement or booth entry.
Compressed Air And Controls
Blast nozzles and breathing air systems can require substantial compressed air planning. Electrical connections, control panels, lighting and safety interlocks should be located where operators can reach them without placing equipment in the blast stream.
Frequently asked questions
What should be measured before installing a blast booth?
Measure the largest parts, handling equipment, booth footprint, collector area, ceiling height, door clearances and available utility routes.
How does dust collection affect booth layout?
The collector needs a practical duct path and enough service clearance for filters, hoppers, fan components and dust handling.
Can a blast booth share space with coating equipment?
It can be part of the same production line, but dust containment, airflow, staging and traffic patterns should be planned so blasting does not contaminate finishing areas.
What utilities are usually coordinated?
Compressed air, electrical power, lighting, controls and dust collector connections are common coordination points.
What symptoms suggest a service review is needed?
Poor visibility, dust escaping the booth, weak recovery, unusual fan noise, air pressure problems or frequent filter loading are useful reasons to inspect the system.