IST (Kresco) Blast Room Installation
An IST (Kresco) blast room is a production area for abrasive surface preparation, not just an enclosure. Installation planning should start with the workpiece, then cover room size, doors, media recovery, dust collection, compressed air, lighting, operator access, collector service and how blasted parts move into coating or inspection.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Room Envelope for the Workpiece
Double D Mechanical reviews the largest parts, racks, carts and lift equipment that need to enter the room. Clearances should support blasting angles, door operation, operator movement and a practical path for parts to enter and leave.
- Confirm length, width, height and handling method for the largest work.
- Review crane, forklift, cart or rail movement near the room.
- Preserve maintenance reach to doors, lights, reclaim and collector equipment.
Recovery Floor and Media Movement
Blast room installation can include recovery floor sections, hoppers, screw conveyors, elevators and separators. The layout should support media movement while allowing inspection, cleaning and access to wear components.
Dust Collection Placement
Collector location affects duct length, service clearance, discharge route and access for filter changes. The collector should be planned with the room layout rather than treated as an afterthought once the enclosure is set.
Compressed Air and Electrical Coordination
Blast nozzles, controls, lighting, reclaim equipment and dust collection may all require coordinated utility routes. Identifying air piping, electrical panels and control locations early helps avoid conflicts with doors and service areas.
Frequently asked questions
What drives blast room size?
The largest workpiece, handling equipment, operator movement, blast angles, door clearance and media recovery layout all influence room size.
Where should the dust collector be located?
The collector location should account for duct routing, filter service, discharge path, electrical access and available space around the room.
What utilities are usually reviewed?
Compressed air, electrical service, controls, lighting, dust collector connections and any media recovery equipment utilities are typically reviewed.
What information helps with blast room planning?
Share part dimensions, handling method, media type, compressor information, equipment drawings, floor conditions and photos of the proposed area.