IST (Kresco) for Aerospace MRO
Aerospace MRO surface preparation can involve fixtures, ground support equipment, repair components and parts that require controlled handling before coating or inspection. IST (Kresco) blast rooms, abrasive blast booths and media reclaim systems should be planned around containment, clean access, dust collection, compressed air, lighting and coordination with adjacent maintenance areas.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Controlled Part Handling
MRO work may include varied part sizes and sensitive surfaces. The blast area should provide clear staging, protected movement, adequate lighting and enough operator room to work without crowding inspection or repair activities nearby.
Containment Around Maintenance Work
Blast dust should be controlled so it does not migrate into assembly, inspection, paint or component storage areas. Door seals, duct routing, collector placement and replacement air should be reviewed as part of the same layout.
Media Recovery And Housekeeping
Media reclaim systems should support the shop's cleaning routine and abrasive handling practices. Access to floors, hoppers, separators, debris screens and wear areas should be kept open for maintenance.
Utility Coordination In Existing Facilities
Aerospace maintenance buildings may have fixed utilities, overhead obstructions and active work zones. Compressed air, electrical service, controls and lighting should be routed to avoid blocking service panels, cranes, lifts or inspection paths.
Frequently asked questions
What should an aerospace MRO site provide before a blast equipment visit?
Provide part sizes, handling equipment, room constraints, adjacent work areas, compressed air information, electrical locations, ceiling obstructions and photos of the proposed route.
Why does containment matter in MRO areas?
Nearby inspection, assembly, coating and storage areas can be sensitive to abrasive dust, so blast room sealing and ventilation need careful review.
How should media reclaim equipment be positioned?
It should match operator cleanup practices while leaving service access to hoppers, separators, augers, screens and wear points.
What makes relocations in MRO facilities challenging?
Existing utilities, active work areas, overhead equipment, security procedures and limited access routes can affect teardown, rigging and reconnection sequence.