IST (Kresco) Heavy Equipment Blast Room Installation
Heavy equipment finishing often involves weldments, frames, buckets, guards, booms and repair assemblies with varied shapes and hard-to-reach edges. Double D Mechanical installs, relocates and services blast rooms, abrasive blast booths, media reclaim systems, exhaust systems and utility connections used around IST (Kresco) equipment in heavy equipment finishing bays.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Machine Size And Handling
Heavy equipment parts may arrive by forklift, crane, cart or low-profile carrier. Installation planning should account for the widest attachment, highest lift point, floor load concerns, door clearance and the need to rotate or reposition parts without blocking exits or service panels.
Blast Coverage For Irregular Weldments
Booms, frames, buckets and housings create shadowed surfaces and pockets where media can collect. The blast area should provide operator access around weld seams, gussets, pin bosses and underside surfaces while keeping spent media moving toward recovery equipment.
Airflow Near Dirty Work
Dust control depends on exhaust volume, inlet placement, collector condition and make-up air. Heavy equipment bays often sit near welding, wash, prep or paint areas, so pressure balance should be reviewed to keep abrasive dust from moving into clean finishing zones.
Controls, Lighting And Utilities
A practical site review should include electrical feeds, compressed air demand, lighting locations, control panel access, collector placement and any overhead crane or door conflicts. Service space around filters, reclaim drives and separator components should stay reachable after production fixtures are installed.
Frequently asked questions
What heavy equipment parts affect blast room layout most?
Large frames, buckets, booms, cabs, guards and welded housings affect door size, operator reach, crane coverage and the way media falls into the recovery system.
Can existing blast equipment be serviced in place?
Many service tasks can be planned in place when access is available to filters, reclaim components, controls, ducts, lighting and worn interior parts.
Why does compressed air need early review?
Blast nozzles can place high demand on compressed air. Capacity, line size, dryer performance and pressure drop affect productivity and surface preparation consistency.
What should be ready before a site visit?
Have bay dimensions, equipment model information if available, photos of the room, utility locations, collector access, duct routing and the largest part envelope.
How can blasting fit with paint booth flow?
The best flow moves parts from dirty preparation to cleaning, masking and coating without crossing clean parts, wet paint traffic or final inspection areas.