Intek for Electrical Switchgear Enclosures
Switchgear enclosure finishing involves tall cabinets, flat panels, doors and hardware that need careful movement through coating and cure. Intek infrared oven installation or relocation should be planned around line speed, part spacing, heat exposure, exhaust, electrical service, make-up air and clear maintenance access.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Panel Exposure Through Cure
Infrared curing depends on how surfaces face the heat source and how parts are spaced. Enclosure doors, cabinets and panels should be reviewed for carrier orientation, shadowed areas, loading height and transition space before and after cure.
Air And Heat Around Enclosures
Exhaust and replacement air should be coordinated so nearby coating areas are not pulled into unstable pressure. Heat spill, drafts and overhead obstructions matter when tall enclosures move close to other finishing equipment.
Electrical And Control Placement
Infrared systems place importance on electrical service, control wiring and access to panels. Routes should avoid operator aisles, rack travel and service doors while fitting around booths, washers, conveyors and building utilities.
Walkthrough Preparation Notes
Gather part envelope dimensions, carrier spacing, coating line layout, utility locations, ceiling height, exhaust options, floor condition and photos of the intended cure area.
Frequently asked questions
What is important when planning infrared cure for switchgear enclosures?
Part orientation, distance to heat sources, shadowing, rack spacing and clear transitions into and out of the cure area are all important planning details.
Why does enclosure height affect installation?
Tall cabinets and frames affect heater placement, overhead clearance, exhaust routing, carrier movement and service access around the equipment.
What utilities should be ready for review?
Electrical service, controls, disconnect locations, exhaust needs, make-up air approach and any nearby process utilities should be ready for review.
What photos help before a site visit?
Photos of the coating line, proposed oven space, ceiling and roof area, utility panels, carrier path and nearby obstructions are helpful.