Grieve for Automotive Bodies and Parts
Automotive finishing can involve vehicle bodies, hoods, doors, brackets, wheels, subassemblies and loose metal parts moving through prep, coating, cure and inspection. Grieve curing equipment may support powder lines, paint booths, prep stations, make-up air units and exhaust systems. Double D Mechanical installs, relocates and services the mechanical connections that tie these areas together.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Vehicle Parts And Loose Components
Full body sections and separate parts place different demands on oven access and staging. Racks, carts, stands and hangers should be reviewed for the largest parts and the smaller components that move through repeated runs.
Prep Station To Cure Route
The finishing route should keep sanding, masking, coating, cure and inspection in a practical order. Coated parts should not be pushed through active prep areas, and operators need enough space around booth doors and oven openings to move without contact.
Make-Up Air And Exhaust Balance
Booths, ovens and prep stations can all influence airflow in the same room. Exhaust ductwork, make-up air, gas piping, electrical service and controls should be coordinated so heat and air movement support the intended process.
- List the largest body section and common parts racks.
- Map prep, coating, cure, cooling and inspection steps.
- Confirm utility locations and roof or wall access.
Maintenance Around Production Cells
Fans, heaters, control panels, doors, seals, lights and filters should remain serviceable after the cell is loaded with racks and stands. Relocated equipment should be reviewed for condition, access and utility changes before it is placed in the new flow.
Frequently asked questions
What automotive part details matter for oven planning?
Part size, rack method, hanger points, coating type, cooling space and the route through prep and inspection all matter.
Can body sections and small parts share a cure area?
They can when the layout, rack spacing and handling method support both part types without crowding the oven entry or exit.
What utilities are usually reviewed?
Gas, electrical power, controls, compressed air, exhaust ductwork, make-up air and roof or wall openings are commonly reviewed.
What affects a Grieve oven relocation?
Equipment condition, removal access, duct routes, control wiring, utility changes, door clearances and the new production path all affect relocation.
What should be ready for a site visit?
Have vehicle or part dimensions, rack information, process flow, utility locations, ceiling height and photos of the finishing area ready.