Global Finishing Solutions open face paint booth installation and relocation
Global Finishing Solutions open face paint booths are often used for parts, assemblies and fabrication work that need a controlled spray area without a fully enclosed booth. Double D Mechanical installs, relocates and connects these systems with attention to capture airflow, exhaust routing, make-up air, workpiece handling and service access.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Capture At The Open Front
The open front makes booth placement especially important. Cross traffic, nearby fans, overhead doors and part staging can affect capture at the face of the booth. The booth should be located so operators can position parts consistently and exhaust air can move through the filters without disruption.
Workpiece Handling Space
Open face booths are commonly used with carts, tables, hanging parts or large fabricated pieces. The layout should include the area in front of the booth, not just the booth footprint. Forklift access, crane coverage, part rotation and masking space can all affect the mechanical layout.
Exhaust And Replacement Air
Exhaust duct routing, fan placement and make-up air should be planned together. The building needs enough replacement air for stable booth capture, and the duct route must leave room for supports, roof or wall penetrations and service at filters and fans.
- Review the largest part size and how it is loaded into the spray area.
- Keep the filter bank accessible for routine changes.
- Coordinate nearby prep tables, racks and cure areas before final placement.
Information For A Site Review
Useful information includes booth model or drawings, part dimensions, coating process, current utility locations, roof or wall construction and photos of the proposed area. If relocating an existing booth, include photos of the exhaust fan, duct run, controls and any utility disconnects.
Frequently asked questions
What is different about installing an open face booth?
The open front must maintain capture airflow while allowing parts and operators to work at the booth face. Nearby air movement and staging areas matter more than they might in an enclosed booth.
Does an open face booth need make-up air?
Exhausted air has to be replaced. The amount and delivery method depend on the booth design and building conditions.
What clearances should be considered?
Allow room for parts, carts, operators, filter service, duct transitions and fan access. The area in front of the booth is part of the working layout.
Can an open face booth be moved to a different wall?
Often it can, provided the new location supports exhaust routing, replacement air, utilities, structural attachment and the required production flow.