Garmat USA automotive refinish booth installation and service
Garmat USA automotive refinish booths support collision, fleet and vehicle finishing work where clean airflow and reliable heat, lighting and exhaust are part of the production process. Double D Mechanical helps install, relocate and service these booth systems while coordinating booth placement, ductwork, make-up air, controls, compressed air and access for ongoing maintenance.
Discuss your installationBrand names identify the equipment discussed. Discuss your equipment model and installation scope with Double D; manufacturer authorization is not implied.
Vehicle workflow around the booth
A refinish booth needs more than a clear interior. The surrounding floor plan should support masking, parts movement, vehicle entry, door opening and post-paint movement without tight turns or blocked aisles. Booth location also affects where painters stage hoses, carts, ladders and filters during daily work.
Balanced air and exhaust routing
Automotive refinish quality depends on a stable airflow pattern through the booth. Exhaust fans, intake filtration, heated make-up air and building pressure should be reviewed together, especially when the booth is moved into a different shop bay or near existing exhaust equipment. Duct runs should be supported, serviceable and coordinated with roof structure and other overhead systems.
- Review intake and exhaust locations before cutting roof or wall openings.
- Allow access to fans, dampers and filters after installation.
- Keep replacement air paths clear of contaminants from adjacent work.
Connections that affect booth operation
Electrical power, lighting, control wiring, gas piping, compressed air and interlocks all influence how the booth starts, sprays and cures. During installation, the work should be sequenced with electricians, fire protection contractors and building trades so panel assembly, duct installation and utility rough-in do not block one another.
Planning a relocation or service visit
For a booth relocation, document the existing booth condition before teardown and identify missing trim, damaged panels or altered controls. For service, note symptoms such as weak airflow, uneven heat, fan noise, filter loading or control faults. Current photos, equipment nameplate information and site measurements help define the next steps.
Frequently asked questions
What should be measured before placing an automotive refinish booth?
Measure the booth footprint, vehicle clearance, door swing, ceiling height, roof structure, utility routes and space needed for filter and fan service.
Can a refinish booth share space with prep work?
The booth can be near prep areas, but intake air should be protected from dust and overspray from adjacent work. Traffic flow should also keep freshly painted vehicles away from sanding and grinding operations.
What utility information is useful before installation?
Useful information includes available electrical service, gas routing, compressed air location, control panel location, roof access and any existing exhaust or make-up air equipment nearby.
Why can booth performance change after relocation?
A new building layout can change duct length, air replacement, static pressure and intake conditions. Those factors can affect draft, heat recovery and finish consistency.
What maintenance access should be preserved?
Leave workable space for filters, fan components, belts, motors, burners, lights, control panels and duct cleanout or inspection points.