Abrasive Blast Booths for Valves and Fittings
Valves and fittings need surface preparation that reaches cast shapes, flanges, ports and exterior details while protecting surfaces that must remain masked. Double D Mechanical installs, relocates and services abrasive blast booths for component coating operations with careful attention to dust collection, handling and recovery.
Discuss your installationFixture Access for Detailed Components
Small fittings and heavier valve bodies may use different tables, hooks, baskets or stands. Booth layout should allow operators to reach around port openings, flanges and stems without dragging hoses across prepared surfaces.
Containment and Dust Collection
Abrasive blasting generates dust and debris that should be captured before it reaches masking, coating or assembly areas. Collector location, duct routes and booth airflow should be planned with service access in mind.
Media Recovery Below Work Areas
Recovery equipment must fit the way parts are handled. Tables, carts and stands should not block grates, sweep areas or hoppers, and cleanup paths should be clear enough for routine housekeeping.
Before the Site Review
Gather the largest and heaviest part sizes, fixture methods, abrasive type, masking requirements, floor constraints, dust collector options and the path from blast to paint.
- Identify which surfaces remain masked
- Show where parts wait before coating
- Note lifting aids, carts and table locations
Frequently asked questions
What makes valves and fittings different from larger fabrications?
They often require close work around detailed surfaces, masked areas and varied part weights within the same booth.
Why plan fixtures with the booth?
Fixtures affect operator reach, blast angle, abrasive cleanup and whether parts can move without surface damage.
Can blast and paint areas be placed near each other?
They can be near each other when dust control, part flow and clean staging are planned carefully.
What maintenance access is important?
Allow clearance for dust collector service, lighting, doors, duct inspection and recovery equipment cleanup.