Storage Tank and Pressure Vessel Booths for LNG Energy Modules
LNG module fabrication can include tank and pressure vessel components that must be prepared, coated and moved into larger assemblies without disrupting module flow. Double D Mechanical installs, relocates and services blast rooms, large paint booths, exhaust ductwork, paint mixing rooms and make-up air equipment for these controlled finishing areas.
Discuss your installationFinishing Before Module Integration
Tank and vessel components may need coating before they are set into structural module frames. Layout decisions should consider when shells, heads, supports and attached fittings leave fabrication, how they are staged and whether coating access will be reduced after assembly.
Room for Lifts and Transfer Paths
Large cylindrical parts require clearance beyond the coated surface. Booth and blast room placement should leave space for cranes, forklifts, carts, temporary stands, door travel and safe movement between preparation, coating, curing or outbound staging.
Make-Up Air Around Module Shops
Module shops often have multiple exhaust sources operating near one another. Paint booth exhaust, blast dust collection, air make-up, heat and building pressure should be reviewed together so one process does not pull air through another work zone.
Coordination With Parallel Trades
Mechanical installation should be sequenced with structural work, electrical feeds, gas piping, compressed air, fire suppression, controls and roof or wall penetrations. Early coordination helps protect access to filters, motors, burners, duct joints, doors and lights after startup.
Planning Notes for a Site Walk
A productive review starts with maximum vessel dimensions, expected handling method, available utility points, proposed equipment location, nearby exhaust systems, ceiling obstructions and any shutdown windows needed for relocation or service work.
Frequently asked questions
How are tank and vessel booths different in LNG module work?
The booth or blast room must fit the component while also supporting the larger module sequence, including staging, lifting, access around frames and movement into assembly areas.
What utilities are usually reviewed?
Gas, electrical service, compressed air, controls, lighting, exhaust fan power, make-up air connections and fire suppression interfaces are typically reviewed early.
Can Double D Mechanical service existing booth equipment?
Yes. Service work can address exhaust components, make-up air units, heaters, duct connections, lighting access, doors, filters and related mechanical items.
Why is building pressure important?
Large exhaust volumes can pull air from adjacent work zones if replacement air is not coordinated, which can affect coating conditions and comfort in nearby fabrication areas.
What information helps with relocation planning?
Existing equipment dimensions, duct routes, utility locations, roof penetrations, control panels, access constraints and the new production route all help define the relocation work.