Abrasive Blast Booths for Oilfield Equipment
Abrasive blasting for oilfield equipment has to reach welded frames, skid pockets, housings and mounting surfaces before coating. Double D Mechanical installs, relocates and connects abrasive blast booths with attention to enclosure fit, dust collection, media recovery, compressed air and movement into the paint area.
Discuss your installationAccess Around Skids and Housings
The booth should allow operators to work around low bases, tall housings and hard corners without fighting hose drag or tight clearances. Loading routes, support stands, cranes and forklift travel all affect the practical booth size.
Dust Control Through the Work Zone
Air movement should carry dust away from the operator and toward collection points while maintaining visibility inside the booth. Large assemblies can block airflow, so collector inlets and room geometry should be reviewed against typical part positions.
Abrasive Recovery and Cleanup Flow
Recovery equipment should match how the shop wants to handle spent abrasive and fines. Floor recovery, hoppers, separators and storage points need maintenance space and should not interfere with loading or unloading finished parts.
Compressed Air and Electrical Needs
Blasting performance depends on compressed air delivery, lighting, controls and dust collector power. Routing these services before booth placement helps avoid exposed runs or service points that are difficult to reach.
Planning Notes for Existing Buildings
Before a site visit, document the proposed booth area, ceiling height, door openings, slab condition, air compressor location, electrical panels and any roof or wall paths for collector ductwork.
Frequently asked questions
What parts of oilfield equipment are hardest to blast?
Skid bases, welded crossmembers, recessed pads, guards and tight inside corners often need extra access and hose reach.
How is dust collector placement chosen?
Placement depends on duct length, available service space, building penetrations, electrical access and how dust moves through the booth.
Can abrasive recovery be added during booth installation?
It can be planned as part of the booth system when floor details, separator location, media handling and maintenance access are reviewed together.
What should be checked before moving a blast booth?
Document the enclosure, collector, recovery equipment, controls, utilities, disconnect points and the receiving area before the move is scheduled.
Why coordinate blasting and painting layouts together?
Prepared parts should move to coating without unnecessary handling or contamination from nearby dust, traffic or staging areas.