Paint booth installation for offshore and LNG modules
Offshore and LNG module coating work needs paint booth installation planned around large frames, skid assemblies, structural members and protective coating workflow. Double D Mechanical installs booths and connected equipment with attention to airflow, exhaust routing, make-up air, utilities and the access needed to keep production moving.
Discuss your installationModule Movement Through the Booth
The booth layout should match how fabricated frames enter, turn, stage and exit. Door openings, floor approach, crane coverage, carts, forklifts, platforms and painter access all affect where booth panels and equipment can be placed.
Airflow Around Dense Fabrication
Module frames can create shadowed areas behind braces, pipe racks and equipment supports. Intake and exhaust placement should support steady air movement across broad surfaces and into tighter geometry without blocking normal work positions.
Exhaust, Intake and Utility Routing
Installation planning should identify duct routes, fan locations, discharge paths, make-up air placement, electrical feeds, control wiring, compressed air and gas or heat connections. Early coordination reduces conflicts with structure, cranes, roof openings and nearby process equipment.
Access After Startup
Filters, lights, fan components, dampers, heater sections and controls need reachable service space. The installation should leave practical access for maintenance without forcing production teams to remove staging or stored material.
Frequently asked questions
What dimensions are important before installation planning?
Provide the largest module dimensions, handling clearances, door requirements, work platform locations and any space needed for coating personnel around the part.
How are other trades involved?
Electrical, structural, fire protection, controls, gas, compressed air and roofing work may all need sequencing around booth installation.
Can a booth support both small parts and large modules?
It can be planned that way, but the layout needs to account for different rack sizes, masking work, staging areas and airflow conditions.
Why is make-up air part of the installation discussion?
Exhausted air must be replaced in a controlled way so booth performance, building pressure and coating conditions are not working against each other.