Metal Fixture Booths for Fabrication Shops
Fabrication shops that build metal furniture and fixtures need finishing equipment that works with welding, grinding, forming, coating and assembly in the same facility. Double D Mechanical installs, relocates and services paint booths, powder coating systems, ovens, exhaust ductwork, make-up air equipment and related utility connections.
Discuss your installationFabricated Parts Moving to Finish
Fixture parts may leave welding and grinding as frames, panels, shelves or display assemblies. The finishing area should sit where parts can be cleaned, coated and staged without dragging fabrication dust into the booth or powder zone.
Part Orientation and Contact Points
Thin frames and display pieces can be awkward to hang or cart. Planning should include rack spacing, hook locations, cart turning radius and operator reach so coating reaches edges, corners and underside surfaces.
Shared Shop Air and Exhaust
A fabrication shop may already have weld ventilation, dust collection and overhead fans. Booth exhaust, make-up air and heater connections should be coordinated with those systems so the finishing area does not upset pressure or pull debris toward clean work.
Installation Sequencing Around Fabrication
Booth panels, ovens, ductwork, gas piping, electrical work and controls often require coordination with other trades and active production. Clear laydown space, rigging routes and outage windows help the installation proceed with fewer surprises.
Frequently asked questions
Can a fabrication shop add finishing equipment without changing the whole plant layout?
Often yes, but the review should include part flow, dust sources, duct routes, utilities, ceiling height and service access before equipment locations are finalized.
What is important for powder coating metal fixtures?
Good powder work depends on clean parts, proper grounding, operator access, balanced booth airflow, suitable oven loading and enough cool-down space.
What utility information should be gathered?
Gather electrical panel locations, available voltage, compressed air, gas service where used, roof or wall exhaust options and control wiring needs.
How should finished parts be staged?
Finished parts should have a protected area for inspection and cool-down before assembly or packaging, with enough clearance to avoid contact damage.