Open Face Paint Booths for HVAC Units and Fans
HVAC cabinets, fan housings and sheet metal panels often move through finishing before final equipment assembly. Double D Mechanical installs, relocates and connects open face paint booths with attention to part staging, exhaust capture, make up air, utilities and the daily flow of panels and housings.
Discuss your installationPart Staging at the Booth Face
Open face booths need clear approach space for carts, racks and operators. Cabinet panels, fan housings and formed sheet metal should be staged so painters can reach edges and returns without blocking the booth opening or nearby aisles.
Capture Across Light Sheet Metal
Air should draw overspray into the booth without pulling light panels off racks or disturbing the spray pattern. Booth depth, face opening, filter area and part placement all affect how well overspray is captured.
Exhaust and Replacement Air Planning
The exhaust fan and duct route should be coordinated with the building structure and any make up air serving the finishing area. Poor replacement air can pull dust from fabrication zones or create drafts across freshly coated panels.
Utilities for Paint Operations
Lighting, compressed air, electrical service and control locations should support repeat work without extension cords or hose paths crossing material flow. Maintenance access to filters, fan components and panels should remain clear.
Site Visit Preparation
Before layout review, gather the largest cabinet or housing dimensions, rack sizes, preferred booth location, ceiling height, utility locations, exhaust route options and photos of upstream fabrication and downstream assembly areas.
Frequently asked questions
Why use an open face booth for HVAC components?
It can suit panels, housings and smaller assemblies that are brought to the booth face on carts or racks instead of driven through a full enclosure.
What affects overspray capture in an open face booth?
Opening size, filter area, fan performance, part placement, booth depth and replacement air all influence capture.
Can light sheet metal parts be difficult to paint in this booth style?
They can be if airflow is too disruptive or racks are poorly placed, so part support and spray position should be considered during layout.
What utilities should be planned nearby?
Compressed air, electrical service, lighting, controls and exhaust connections are common planning items.
What should be measured before installation?
Measure the largest parts, carts, racks, ceiling height, available wall or roof routes and the space needed for operators at the booth face.