Fabricated Metal Finishing for Switchgear Work
Electrical switchgear enclosure production includes fabricated doors, panels, frames, covers, bases and brackets that often require a durable finish before assembly. Double D Mechanical installs, relocates and services paint booths, powder coating systems, cure ovens, exhaust systems, make-up air equipment and related utility connections for these finishing operations.
Discuss your installationPanels, Doors and Support Parts
Switchgear work can mix flat panels, bent doors, frames and small support parts. Booth and oven planning should include part orientation, hanging points, edge coverage, cart spacing and protection of finished surfaces before assembly.
Clean Flow Into Assembly
Finished enclosure parts should move from coating and cooling toward assembly without passing back through cutting, welding or grinding areas. Layout decisions should account for inspection, touch-up, hardware staging and protected storage.
Powder and Paint System Connections
Coating equipment depends on coordinated exhaust, compressed air, electrical service, controls, lighting and make-up air. Ovens also require attention to heat source connections, door clearance, fan access and service space around mechanical components.
Planning Around Enclosure Lines
Before a walkthrough, gather the largest panel and frame sizes, rack dimensions, material flow, current utility locations, ceiling height, duct route options and any production areas that must stay open during installation or service.
- Measure loaded racks, not just individual panels.
- Identify where coated doors and covers cool before assembly.
- Review aisle width for carts and lift equipment.
Frequently asked questions
What equipment is used for fabricated switchgear enclosure parts?
Depending on the finish, equipment may include powder booths, powder lines, cure ovens, open-face paint booths, exhaust ductwork and make-up air units.
Why is part orientation important for enclosure panels?
Orientation affects edge coverage, visible surface protection, operator reach and how parts can be handled without contact marks.
What utilities should be reviewed early?
Electrical capacity, compressed air, gas service where used, control wiring, exhaust penetrations and replacement air locations should be reviewed early.
Can finishing equipment be serviced while production continues nearby?
Sometimes, but service access, lockout needs, nearby traffic, filter locations and utility isolation points should be reviewed before work is scheduled.