Open Face Paint Booths for Fabricated Metal Parts
Fabricated metal parts can range from brackets and weldments to panels, housings and frames that need liquid coating before downstream assembly or shipment. Double D Mechanical installs, relocates and connects open face paint booths around part size, work access, exhaust, make up air, utilities and the way material flows through the plant.
Discuss your installationBooth Fit for Varied Fabrications
An open face booth should fit the largest weldment or panel without forcing the operator outside the intended spray area. Planning should account for cart size, rack depth, forklift approach, part rotation and any masking or touch up work that happens at the booth.
Air Movement Across Irregular Parts
Fabricated parts often have corners, flanges, tubes and recessed surfaces that change overspray behavior. Exhaust and make up air should be reviewed together so airflow moves through the work zone without pulling dust from cutting, grinding or assembly areas.
Duct, Power and Air Connections
Booth installation may involve exhaust ductwork, fan mounting, compressed air, electrical service, lighting and controls. Utility routes should be coordinated before the booth is set so final connections do not block access panels or production aisles.
Placement in the Production Sequence
The booth should sit where parts can move from prep to coating to dry or cure space with minimal extra handling. Keep coated parts away from fabrication dust, forklift traffic and areas where parts may be bumped before the finish is ready.
Site Details to Have Ready
Before a walkthrough, gather part size ranges, weights, rack or cart dimensions, coating materials, booth drawings if available, ceiling height, existing exhaust information and photos of the proposed location.
Frequently asked questions
When is an open face booth useful for fabricated parts?
It fits many shops that spray discrete parts on carts or racks and need front access for loading, positioning and coating.
What affects booth size?
The largest part, fixture depth, operator reach, spray pattern, cart movement and filter access all affect the practical booth size.
Can the booth be installed near fabrication equipment?
It can be placed nearby only if airflow, dust control, traffic, clearances and coating protection are addressed in the layout.
What should be reviewed before relocation?
Review booth condition, fan and ductwork, utility paths, roof or wall openings, new part flow and access for maintenance after the move.