Paint booth installation for aircraft and components
Aircraft and component finishing can involve full exterior work, removable parts, prep areas and paint mixing support. Double D Mechanical installs paint booths and aircraft paint hangar equipment with attention to airflow, exhaust, replacement air, utilities, clearances and production sequencing.
Discuss your installationWorkpiece envelope and access routes
Aircraft exteriors and separate components require different booth layouts. Installation planning should start with the largest aircraft or component, the way it enters the space, and the access needed for lifts, stands, carts and painters.
Airflow across broad surfaces
Large curved surfaces and detailed component areas need consistent airflow through the booth. Intake placement, exhaust sections and make-up air delivery should be coordinated so air movement supports the finishing process.
Exhaust, heat and utility connections
Booth installation involves exhaust fans, ductwork, air make-up equipment, electrical service, controls and often heat. These connections should be sequenced with building openings, roof work and other trades before booth panels are enclosed.
Support spaces for prep and mixing
Aircraft finishing areas may include prep stations and paint mixing rooms near the main booth or hangar. Their placement should support material movement, operator access, ventilation routing and separation from unrelated plant traffic.
Site information to collect early
Helpful planning details include equipment drawings, aircraft or component dimensions, door openings, ceiling height, floor conditions, utility locations, roof access, lift requirements and expected maintenance access points.
Frequently asked questions
What drives paint booth layout for aircraft work?
The workpiece size, entry path, lift access, painter movement, airflow strategy, exhaust route and connected support rooms all influence the layout.
Can aircraft components use a smaller booth than exterior work?
Yes, component finishing may use a different booth size or configuration, depending on part dimensions, handling method and process needs.
Why is make-up air important in aircraft finishing?
Large exhaust volumes must be replaced in a controlled way so booth airflow stays predictable and surrounding spaces are not pulled out of balance.
What trades usually need coordination?
Mechanical, electrical, controls, fire protection, roofing, structural and plant maintenance teams may all need to coordinate around the installation.
What should be ready before a site visit?
Have floor plans, equipment drawings, part dimensions, utility information, photos of the area and notes about lifts or stands used during painting.