Booth Exhaust Systems for Agricultural Implements
Agricultural implement finishing relies on exhaust systems that can capture overspray, move air across large steel parts and connect cleanly to the building. Double D Mechanical installs, relocates and services booth exhaust systems for finishing areas used on farm implement frames, attachments and metal assemblies.
Discuss your installationCapture Across Long Welded Assemblies
Toolbars, frames, guards and attachments can interrupt booth airflow and create pockets near corners or recesses. Exhaust planning should consider how parts are loaded, where painters stand and whether the booth uses side, rear or floor level capture.
Duct Paths Through the Building
Exhaust ductwork must be routed around structure, cranes, mezzanines, utilities and roof conditions. Early review helps identify whether straight runs, transitions, supports and access doors can be placed without crowding production movement.
Air Replacement and Pressure Behavior
Exhaust performance depends on the air coming back into the space. Coordination with air make up equipment, doors and adjacent rooms helps reduce drafts that can disturb coating quality or pull dust into the booth.
Filter and Fan Service Planning
Filters, fan bearings, motors, belts, cleanout points and discharge locations need usable access. Service planning is especially important when implement parts require carts, racks or forklifts near the booth during normal operation.
Information for Layout Review
A good walkthrough starts with booth dimensions, fan data, duct route limits, part sizes and a plain description of how parts enter, rotate and leave the finishing area.
- Largest and heaviest assemblies finished in the booth
- Current filter type and changeout access
- Available roof or wall exit locations
- Nearby cranes, doors and utility corridors
Frequently asked questions
What causes poor exhaust performance in an implement booth?
Common issues include undersized or obstructed ductwork, loaded filters, fan problems, poor make up air balance and part placement that blocks the intended airflow path.
Does exhaust ductwork have to be changed during a booth move?
Often it does. A new location changes duct length, roof penetrations, support points, fan access and the relationship between exhaust and replacement air.
Why review material handling with exhaust work?
Forklifts, carts and overhead handling can affect where ducts, fans, filter access and supports can be placed without interfering with production.
What should the plant provide before planning begins?
Provide booth drawings if available, photos of the current setup, fan nameplate information, roof or wall constraints and the expected production flow.